Here in week 3 I made some changes in my planes I will no longer be using all the wall timers but have chosen to go with a Neptune Aqua Controller Jr. to do the job that the timers where going to do.
I continued with the sheeting and built in a place to house the controller . I also ran the power from the breaker's to the outlets .
I started to install the DIY dosing pump that I will be using. I also started to label the layout as can be seen with the chosen placement of the RO/DI unit.
As you can see I cut out the opening that will allow air circulation and the power cords form the Lighting & power heads to the controller. I will be adding fans at the other end of the canape and vents on the top over the controller.
I continued with the sheeting and built in a place to house the controller . I also ran the power from the breaker's to the outlets .
I started to install the DIY dosing pump that I will be using. I also started to label the layout as can be seen with the chosen placement of the RO/DI unit.
As you can see I cut out the opening that will allow air circulation and the power cords form the Lighting & power heads to the controller. I will be adding fans at the other end of the canape and vents on the top over the controller.
No comments:
Post a Comment